AVR GCC development environment test software: blinking LED using atmega8 timer2

See the following article for details:
http://tuxgraphics.org/electronics/200904/avr-c-programming.meta.shtml

Edit the Makefile and adjust it to the type of programmer that you are using.

Mac and Linux
To compile type the command:
make

To compile and load use:
make load

Windows
If you run Windows and you have winavr installed then check the winmake.bat
file. Edit it and adjust the path as needed. After that just double click
on the winmake.bat file to compile.

Files
ledtest.c        # the c source code for ATmega8
ledtest_pre.hex  # pre-compiled loadable object in case you have
                 # trouble to compile the software
Makefile              # Makefile 
README.htm            # this file
test-circuit-led.jpg           # schematic as jpg image


History:
version 0.1: 2009-04-12, first Version
version 0.2: 2009-05-07, corrected fault in assignment of TCCR2
-------------------------------------------

Copyright: GPL
Written by guido socher <guido at tuxgraphics.org>
-------------------------------------------